Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

Particular Application Bandwidth Utilization on Cisco Router

Hi team, Currently one of my critical payment application is running through internet and due to bandwidth congestion some of transactions are declining.

So we decided to procure a Point to Point leased line to that merchant. And we don't know how much bandwidth is required for that application and we know the peak bandwidth utilization timings is between morning 8.00 to 8.05 AM only. So is there any mechanism or commands to calculate the bandwidth utilization on Cisco router of that particular application on this window.

How to know what is bandwidth required for that application on our internet cisco router. (Like IP accounting, IP flow)

 

 

 

1 REPLY
Super Bronze

DisclaimerThe Author of this

Disclaimer

The Author of this posting offers the information contained within this posting without consideration and with the reader's understanding that there's no implied or expressed suitability or fitness for any purpose. Information provided is for informational purposes only and should not be construed as rendering professional advice of any kind. Usage of this posting's information is solely at reader's own risk.

Liability Disclaimer

In no event shall Author be liable for any damages whatsoever (including, without limitation, damages for loss of use, data or profit) arising out of the use or inability to use the posting's information even if Author has been advised of the possibility of such damage.

Posting

The problem with stats from IP accounting or netflow, they indicate how much bandwidth was used, but your question was knowing how much bandwidth is needed.

Well, on some platforms and IOS versions, Cisco implemented QoS Bandwidth Estimation using Corvil Technology, see http://www.cisco.com/c/en/us/td/docs/ios/qos/configuration/guide/convert/qos_bndwth/qos_bndwidth_est.html for more information.

If your platform supports this technology, you would also need to SNMP poll the estimator's stats, during the time period of interest.

50
Views
0
Helpful
1
Replies
CreatePlease to create content