Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

partition avoidance about IS-IS

Hi,

Is there anybody know what is the command "partition avoidance" in ISIS used for? and can you please give an example for me, thanks a lot!

vagrant

2 REPLIES
Silver

Re: partition avoidance about IS-IS

To cause an IS-IS Level 1-2 border router to stop advertising the Level 1 area prefix into the Level 2 backbone when full connectivity is lost between the border router, all adjacent Level 1 routers, and end hosts, use the partition avoidance command in router configuration mode. To disable this output format, use the no form of the command

New Member

Re: partition avoidance about IS-IS

I have got it, Thank you very much. But I still don't know the advatange of it, can u please give me an example with topology? ^_^

338
Views
0
Helpful
2
Replies
CreatePlease login to create content