I am using 4507E catalyst as my HUB location which is connected with a Cisco 6509 Core switch and controlled by AAA server. I want to recover my HUB locations password. how can I do this ?I have tried to change it thru Confreg 0x2142 but again on reset, it asks the username instead of Switch> Please help.
I already tried this method but on resetting the hub switch, it again asks the username for authentication instead of Switch> prompt. I also tried to unplug the Core Switches Uplink cable to discunnect the AAA Server but the result is same.If you have any idea, please help me out.
Do you get to the rommon prompt and then enter confreg 0x2142 ? If the register has been set I don't know how it could give you anything other than a switch with a blank config as it bypasses your startup config in this mode .You then copy your startup into running config and you modify whatever passwords you are using whether its a vty password or a username password and or enable secret password .Change the config register back to 0x2102 and then write mem the box and reload. Have never seen the recovery procedures fail. Can you post your exact procedures you are following otherwise I would look over that doc and again follow it step by step .
We are pleased to announce availability of Beta software for 16.6.3.
16.6.3 will be the second rebuild on the 16.6 release train targeted
towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are
looking for early feedback from customers befor...
Introduction Featured Speakers Luis Espejel is the Telecommunications
Manager of IENova, an Oil & Gas company. Currently he works with Cisco
IOS® and Cisco IOS XE platforms, and NX to some extent. He has also
worked as a Senior Engineer with the Routing P...
In this session you can learn more about Layer 3 multicast and the best
practices to identify possible threats and take security measures. It
provides an overview of basic multicast, the best security practices for
use of this technology, and recommendati...