Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

password recovery

Hi,

I have a swich with redundant sup engine and need to break the enable password of the same.

Is it required to remove the secondary sup engine from the chassis when I reload and put the primary sup engine in rommon mode?

Or will the seconfdary sup active during this process?

Thanks

Richard

1 REPLY

Re: password recovery

Hi,

I have a swich with redundant sup engine and need to break the enable password of the same.

Is it required to remove the secondary sup engine from the chassis when I reload and put the primary sup engine in rommon mode?

Or will the seconfdary sup active during this process?

Thanks

Richard

Richard,

Remove secondary sup engine

proceed with password recovery for primary Sup engine onece its come up properly insert secondary sup engine for sync config,check out the below link for step by step procedure.

http://www.cisco.com/en/US/products/hw/switches/ps663/products_password_recovery09186a00800945f7.shtml

https://cisco.com/application/pdf/paws/30222/178.pdf

Hope to Help !!

Ganesh.H

Remember to rate the helpful post

268
Views
0
Helpful
1
Replies