Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Bronze

Patching is not available since the system is not running from an installed

I get the message in the conversation title when I enter the sh ver command "Patching is not available since the system is not running from an installed image. To install please use the "install file" command".

What should be done here?

7 REPLIES
Hall of Fame Super Bronze

Re: Patching is not available since the system is not running fr

It seems you've downloaded and installed the Software Modularity version of that code.

Please refer to:

http://www.cisco.com/en/US/prod/collateral/switches/ps5718/ps708/product_promotion0900aecd80312844.htm

For any questions you may have regarding that feature code.

HTH,

__

Edison.

Bronze

Re: Patching is not available since the system is not running fr

I actually just installed this switch but it is possible that the previous owner downloaded and installed the software that you mentioned. How do I verify that he actually downloaded that software? Is there something that I need to do to either remove this from the sh ver output or complete the install? I used the "sh install run" but there were no output.

Hall of Fame Super Bronze

Re: Patching is not available since the system is not running fr

No verification is needed, you are running the Software Modularity code.

You can always go back to the regular code by downloading and installing, just like a typical upgrade.

Bronze

Re: Patching is not available since the system is not running fr

I am a bit conrned because Solarwinds (monitor software) is showing the device using 92% of its memory. But, the show memory output has the following output:

System Memory: 524288K total, 252632K used, 271656K free, 1000K kernel reserved

Lowest(b) : 278147072

Hall of Fame Super Bronze

Re: Patching is not available since the system is not running fr

Solarwinds is not reporting that System Memory value. Solarwinds is reporting the CPU memory utilization.

show processes is what you are looking for: http://www.cisco.com/en/US/docs/ios/fundamentals/command/reference/cf_08.html#wp1017986

HTH,

__

Edison.

Bronze

Re: Patching is not available since the system is not running fr

CPU utilization for five seconds: 4%; one minute: 4%; five minutes: 3%

I am baffled!!!

Hall of Fame Super Bronze

Re: Patching is not available since the system is not running fr

Not sure where SolarWinds is getting that information then, contacting their tech-support should be the next course of action.

__

Edison.

2583
Views
4
Helpful
7
Replies
CreatePlease to create content