Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

PBR 4006 Supervisor III

Hi:

I need implement PBR in a switch 4006 with supervisor III, i only found information for the same supervisor III but for switchs 4500, the question is, the comands supported by supervisor III in a 4500 are suported by the same supervisor III in 4006? or, can i implement PBR (route-map in a interface)

in 4006?

thanks in advance.

1 ACCEPTED SOLUTION

Accepted Solutions
Silver

Re: PBR 4006 Supervisor III

You can implement PBR on sup3. In Cat4000/4500 switches , all the intelligence is in the sup and chassis for the most part has no relevance to what features can or cannot be enabled. You can implement PBR in 4006 using the example you found for 4500.

thanks

Salman.

2 REPLIES
Silver

Re: PBR 4006 Supervisor III

You can implement PBR on sup3. In Cat4000/4500 switches , all the intelligence is in the sup and chassis for the most part has no relevance to what features can or cannot be enabled. You can implement PBR in 4006 using the example you found for 4500.

thanks

Salman.

Community Member

Re: PBR 4006 Supervisor III

OK thanks a lot

123
Views
0
Helpful
2
Replies
CreatePlease to create content