09-07-2007 09:10 AM - edited 03-05-2019 06:20 PM
Hi:
I need implement PBR in a switch 4006 with supervisor III, i only found information for the same supervisor III but for switchs 4500, the question is, the comands supported by supervisor III in a 4500 are suported by the same supervisor III in 4006? or, can i implement PBR (route-map in a interface)
in 4006?
thanks in advance.
Solved! Go to Solution.
09-07-2007 09:17 AM
You can implement PBR on sup3. In Cat4000/4500 switches , all the intelligence is in the sup and chassis for the most part has no relevance to what features can or cannot be enabled. You can implement PBR in 4006 using the example you found for 4500.
thanks
Salman.
09-07-2007 09:17 AM
You can implement PBR on sup3. In Cat4000/4500 switches , all the intelligence is in the sup and chassis for the most part has no relevance to what features can or cannot be enabled. You can implement PBR in 4006 using the example you found for 4500.
thanks
Salman.
09-07-2007 09:28 AM
OK thanks a lot
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide