I have two internet link connected to same router. I would like to do PBR in our router . Email via ISP 1 and http via ISP 2. But here i need failover over fauction too. In the event of any of ISP link is down, the specified PBR policy must use another available ISP link to route the traffic? Both ISP link is DSL. Sample configuration needed. Thanks
Please see the post which you have opened in WAN, Switching and Rounting forum.
Can you please close either one of the post, so that fellow community member can shed their light on single discussion at one place only. It would also be good for you, as you can keep track of the discussion at one place only.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...