Currently I have 1 router that performs pbr to send http,https traffic thru a bsd captive portal and all other traffic out a different gateway. I will be getting 2 Cisco 3745 routers soon (they are being replaced by 3845s) and would like to replace the single router with the pair of 3745s running glbp host-dependant. I would also like to send traffic from the 1st glbp router to one captive portal and send traffic from the 2nd glbp router to another captive portal. I would also like to have the router/portals be fault tolerant - if the router and/or portal svr fail, traffic gets sent to the working pair. My 1st thought was to use sla policies with an icmp check against the portals from each router
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...