Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

PBR and NAT problem on 2611XM

I have been trying to configure PBR and NAT on a 2611XM edge router (IOS 12.2(46a)) in order to make use of a newly acquired second internet feed. The intent is that this feed will service all of our "outgoing" http/https traffic, freeing up valuable bandwidth on our original main Internet feed for public access to our web services (http/https/Citrix/Webmail/VPN/etc.)

To accomplish this, I have tried to configure PBR to policy-route the outbound http/https traffic to ISP#2. Things seem to work for some clients and some sites but not for everything as I expected. ACL rules are being hit and appropriate nat translations appear in "show ip nat trans", but some sites simply timeout from some clients, but not from others.

I have attached an annotated config and a net diagram to help describe my situation. Real IP addresses have been replaced with fictitious IPs.

If anyone has any suggestions I'd love to hear them.

Thanks, in advance.

John

1 REPLY
New Member

Re: PBR and NAT problem on 2611XM

Here's the network diagram.

133
Views
0
Helpful
1
Replies