I need to enable PBR on my main internet gateway. I have between 300-500 Mbps of traffic on a NPE-G1 and my cpu is at 20%. I need to send some trafic another way to test a new firewall. Will this hardware support it?
NPE-G1 is designed for 1,018,000pps and for 521.22Mbps in CEF switching.These performances are given to 64byte packet size, so really in worst case. Could you please tell me what amount of traffic you want to add via PBR.
In normal design, it's preferable to get CPU under 50%
I now have around 90K (45K each direction) of PPS.
I have a pair of G1 on both side of my old (and new) firewall. I need to test the incoming policy of my new firewall. The goal is to have 1 or two host on the internet using the new firewall while the rest of the trafic is going tru my old one.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.