Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

PBR Features

Hi All,

I am currently testing the PBR feature and i would like to know how it functions.

the scenario is the following:

we would like to redirect the traffic to SWITCH2 when the destination is an IP from the subnet 10.160.130.0.

i am doing the test from switch 1 by doing an extended traceroute.

the source IP is SVI 990 10.160.123.145.

the test fails, i am still able to reach the directly connected server on switch1. any explanation ?

the configuration and a network diagram that illustrates the scenario are attached.

thank you.

Jean

4 REPLIES

Re: PBR Features

Jean,

First of all, Router generating traffic will not work. You have to use "ip local policy route-map".

A defined route-map named "PBR_Route_Map_Testing". At the interface level I saw "PBR_Route_Map". Typo?

I would test by using other hosts in network,10.160.123.0/24.

HTH,

Toshi

New Member

Re: PBR Features

Hi Toshi,

yes it's a type so i need to use the local policy route-map in case i need to test the PBR from the router itself?

thanks

Re: PBR Features

Jean,

You got it. That's what I'm talking about.

HTH,

Toshi

New Member

Re: PBR Features

Thanks Toshi, this was very helpful.

136
Views
0
Helpful
4
Replies