Cisco Support Community
Showing results for 
Search instead for 
Did you mean: 

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

PBR on 6500

Hello Experts,

We have a 6500  where we configured a PBR on one SVI  as discribed on the file attached,

when make the traceroute from the server we see that the PBR is working very well  ( trafic go through GW2 )

for test purpose we created an SVI 20  on Access swtich : when we made a trace route from Access SW with source SVI 20 the 6500 don't apply the PBR for this kind of traffic. ( traffic go through default GW  GW1) !!!!

Thanks for your help

VIP Super Bronze

PBR on 6500


Most small switches with basic license don't support PBR.  For example; if you are using a 3560 or 3750 with IP base license, it will not support PBR.  You would need IP services license to do PBR.


New Member

PBR on 6500


Thanks for your answer,

The PBR is applayed on the 6500 SVI 20 .

when we made the traceroute from the server ( IP@ : ) we see that the GW is corrcet PBR worked very well.

when we made the trace from Aceess Switch ( trace source is the traffic follow the default path!!! PBR not applayed !!!.


VIP Super Bronze

PBR on 6500

Thanks for the clarification

Can you post the PBR config from the 6500?

New Member

PBR on 6500


here you are :

access-list 100 permit ip

route-map PBR_NET15 permit 10

  match ip address 100

  set ip next-hop

int vlan 20

ip address

ip policy route-map PBR_NET15

Kind regards


New Member

PBR on 6500

I met a similar problem as this. The PBR doesn't work as expected. It's overided by static route.

Just posted a question and hope can find answers

CreatePlease to create content