Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

PBR on Cat 4500 with Supervisor 6E

Hi all,

I'm trying to configure PBR on a Catalyst 4500 with Supervisor 6E running version 12.2(46)SG Enterprise Services.

I'm not able to configure PBR on the interfaces using the command ip policy-map.

Did this feature disappear on this Supervisor???

I've already searched on the Feature Navigator and PBR is not on the list for either license types!

I'm replacing a Sup3 that has that feature configured.

Any help?

Thanks,

Paulo

I

5 REPLIES
New Member

Re: PBR on Cat 4500 with Supervisor 6E

OK, just checked that PBR is not supported on Supervisor 6-E.

Is there any reason for this? Will it be supported in the future?

New Member

Re: PBR on Cat 4500 with Supervisor 6E

did you use same IOS 12.2.46.SG on SUP3 or not?

New Member

Re: PBR on Cat 4500 with Supervisor 6E

The Supervisor 3 is running 12.2(25)EWA8.

I believe that PBR would be working on Sup3 on version 12.2(46)SG. The limitation is really on Supervisor 6-E which does not support PBR.

New Member

Re: PBR on Cat 4500 with Supervisor 6E

may you pls try for me that whether PBR is working on SUP3 with 12.2(46)SG, because the feature navigator indicate that PBR is not supported for this IOS..thanks..

http://tools.cisco.com/ITDIT/CFN/jsp/index.jsp

New Member

Re: PBR on Cat 4500 with Supervisor 6E

Hi,

Don't worry about that version for Supervior 3 because version 12.2(46)SG is for Sup6-E only.

The latest version for Sup3 is 12.2.25-EWA14 which certainly supports PBR (Must be Enhanced L3 license) because Sup3 supports that feature.

The limitation I've found is in the Hardware not in the Software.

292
Views
0
Helpful
5
Replies
CreatePlease to create content