Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

PBR on SVI and Next Hop

I have a layer 3 switch (4506) connected to a WAN router.

The 4506 has several SVI's which are the gateways to different subnets (i.e. 10.208.2.x, 10.208.3.x, 10.208.4.x, etc.).

After creating a route-map, do I apply it to the incoming physical port on that 4506 or do I apply it to the SVI for that subnet?

Second, does my next hop have to be an interface (ip address) on the same 4506 or could it be on the WAN router?

Thanks in advance.

2 ACCEPTED SOLUTIONS

Accepted Solutions
Silver

Re: PBR on SVI and Next Hop

yes. you apply it to the SVI interface.

set ip next-hop {ip-address [...ip-address] }

Syntax Description

ip-address

IP address of the next hop to which packets are output. It must be the address of an adjacent router.

Hall of Fame Super Silver

Re: PBR on SVI and Next Hop

Hello David,

the ip policy command has to be applied on SVI(s) interfaces

>> Second, does my next hop have to be an interface (ip address) on the same 4506 or could it be on the WAN router?

the IP next-hop has to be an IP address of ANOTHER box, the WAN router or other device to which you want to direct traffic

Hope to help

Giuseppe

3 REPLIES
Silver

Re: PBR on SVI and Next Hop

yes. you apply it to the SVI interface.

set ip next-hop {ip-address [...ip-address] }

Syntax Description

ip-address

IP address of the next hop to which packets are output. It must be the address of an adjacent router.

Re: PBR on SVI and Next Hop

Hi,

Yes you can apply check out the below link hope that helps out your query !!

http://www.cisco.com/en/US/docs/switches/lan/catalyst3560/software/release/12.1_19_ea1/configuration/guide/swiprout.html#wp1052491

Regards

Ganesh.H

Hall of Fame Super Silver

Re: PBR on SVI and Next Hop

Hello David,

the ip policy command has to be applied on SVI(s) interfaces

>> Second, does my next hop have to be an interface (ip address) on the same 4506 or could it be on the WAN router?

the IP next-hop has to be an IP address of ANOTHER box, the WAN router or other device to which you want to direct traffic

Hope to help

Giuseppe

2045
Views
0
Helpful
3
Replies
CreatePlease to create content