Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

PBR problems

Hi,

I'm trying to set up a PBR on my 4506 switch: (Cisco IOS Software, Catalyst 4500 L3 Switch Software (cat4500-IPBASEK9-M), Version 12.2(31)SGA, RELEASE SOFTWARE (fc3))

But, when I'm on the interface line configuration: [swcore(config-if)] the switch doesn't accept the command "ip policy route-map IT", it appears the switch doesn't have the command.

And I just have configured the access-lis t and i'vve created the route map IT.

I think its because the IOS version.

What could be the cause?

Thanks

Tauer

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Blue

Re: PBR problems

Tauer

I don't believe PBR is supported on the Sup II+ as this supervisor is really a L2 sup with only some basic L3 capabilities.

The SupIV would support PBR as it is a L2/L3 supervisor.

The difference between BASE and Enterprise is primarily enhanced L3 routing eg EIGRP/OSPF/BGP and some additional L3 functions such as PBR.

Jon

6 REPLIES
Hall of Fame Super Blue

Re: PBR problems

Tauer

Which supervisor are you running ?

Regardless i don't believe PBR is supported in the IPBASE version. You need the Enterprise version of code.

Jon

New Member

Re: PBR problems

Hi Jon,

I'm running the Supervisor IV.

What is the diference between both...IPBASE and Enterprise?

Thanks

Tauer

New Member

Re: PBR problems

Sorry Jon,

I'm runnig Supervisor II+

Thanks

Tauer

Hall of Fame Super Blue

Re: PBR problems

Tauer

I don't believe PBR is supported on the Sup II+ as this supervisor is really a L2 sup with only some basic L3 capabilities.

The SupIV would support PBR as it is a L2/L3 supervisor.

The difference between BASE and Enterprise is primarily enhanced L3 routing eg EIGRP/OSPF/BGP and some additional L3 functions such as PBR.

Jon

New Member

Re: PBR problems

Thank you Jon,

Then, I'll update my IOS version.

Regards

Tauer

New Member

Re: PBR problems

Hi Jon,

I have a Catalyst 4507R with Sup V.

Platform: CAT4500-SUP5

IOS: 12.2(31)SGA4

Feat.set: ENTERPRISE SERVICES SSH

It supports the normal PBR. I'm looking for support of PBR Recursive Next Hop. Do you know if the higher version of IOS, e.g. 12.2(50)SG1, supports this feature?

Feature Navigator says it is not supported on a CAT4500 platform. But Feature Navigator can be inaccurate sometimes.

Please advise.

Thank you.

B.Rgds,

Lim TS

263
Views
0
Helpful
6
Replies