Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

PBR, Route MAP set interface option

Hello:

In the following configuration

Access-list 300 permit ip 192.168.1.0 0.0.0.255 172.16.0.0 0.0.0.255

Route-map MAIN permit 1

                              match ip address 300

                             set interface Gi3/48

interface vlan 2

               ip address 192.168.1.254 255.255.255.0

               ip policy route-map MAIN

Does the interface Gi3/48 in the set interface option have to be a L3 interfaces? I mean, does it have to have and Ip address?

Regards and thanks in advance,

Faimy

2 REPLIES
Cisco Employee

Re: PBR, Route MAP set interface option

I tried it on my lab switch and it doesnot throw me an error. I beleive that it should work but i cannot push the traffic across it to make sure its working.

Cheers,

Cisco Employee

Re: PBR, Route MAP set interface option

What platform are you configuring this on?  I believe it needs to be L3, but it may depend on platform.

For instance if this is a 6500 you can see what is supported here in the config guide:

http://www.cisco.com/en/US/docs/switches/lan/catalyst6500/ios/12.2SXF/native/configuration/guide/layer3.html

The Policy Feature Card (PFC) and any Distributed Feature Cards (DFCs) provide hardware support for policy-based routing (PBR) for route-map sequences that use the match ip address, set ip next-hop, and ip default next-hop PBR keywords.

968
Views
0
Helpful
2
Replies
CreatePlease to create content