I have a pc user whose pc connects to a switch. The port her pc connects to need to be put into vlan 202. However when that happens her pc cannot find the tree. As soon as I take her pc out of vlan 202 and put it into vlan1 she is able to work fine.
I have no vlan 202 and recreated the vlan but that made no difference. I also tried to plug her into another port on another switch.
They experienced a power failure and after the power was restored, this problem occurred.
It's a layer 2 switch. C2950. Basically the port the user connects to is in vlan 202. When I check to make sure the switch can reach the default gateway I get a response. So the route to the outside world looks fine. I suspect 1 of 2 things here. Either the config has lost some settings or the vlan got corrupted. My colleague on site said the people who were in vlan 202 are not and those who are not in vlan 202 are. SO it could also be someone who unplugged cables and plugged them back into the wrong switch.
Currently I can also ping the servers from the switch.
What do you mean with "Check the config and see if vlan 202 is allowd on trunk ports to go to the network if this is a layer 2 switch"?
Thank you for the help, but I must say I am a bit lost. I have attached the run config.
There are 2 configs. The customer has a L3 switch on site which runs trunks to the switches on the separate floors. I have also included the specific switch on the first floor which is giving us problems.
Where is the L3 interface for vlan 202 ie. on which switch or router.
When you say the switch can ping the default-gateway is this in vlan 1 or vlan 202. Because this is a layer 2 switch the fact that the switch can ping the default-gateway does not mean you have connectivity for vlan 202.
As Shri says, a copy of the configs would be good.
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...