I am replacing a Cisco 2924 with with a 2950. I have a PC that is accessing vlans 55-61 on the 2924 with the command switchport muti vlan 55-61. What is the command to use on the 2950? I have tried the command :
It seems the multi vlan command feature is only supported on the 2900 and 3500 series switches, personally I have never had the need to used this command but from what I just read although switchport multi vlan is not the same as if you were using dot1q trunk but it resembles same effect , so you may try trunking the port and test it as long the PC NIC supports dot1q you should be good.
We are pleased to announce availability of Beta software for 16.6.3. 16.6.3 will be the second rebuild on the 16.6 release train targeted towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are looking for early feedback from custome...