Can someone tell me if I can have seperate routes setup on a per vlan basis on a 6509 running in native mode (12.2 IOS). I'd like to setup something like "virtual router 1" for vlan 2 and "virtual router 2" for vlan 3..etc..
What I've done is cosolidate a stack of switches (a few for our production environment and one for our coporate side) into the one core 6509. Each side, corporate and production, have a seperate firewall and internet connection. On this 6509 I've configured vlans for corp and prod and an SVI for both. I'd like to plug in my devices and point them to the SVI of their vlan as a gateway. Then let the 6509 route the traffic out the right firewall.
So it sounds like the policy routing is what I should be focusing on, correct?
As for the MPLS VPNs, I think that will be more than I need. I looked at them some, but do not need a VPN for this traffic.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.