I am seeing the logs belw on 4900M switches recently installed with multicast PIM spase-mode enable. Nothing fancy enable on the interfaces between the switches, just PIM spase-mode and switches have PIM neighbor enable. We are seeing the logs on the 4900M and also switches with PIM direct neighbor peering with the 4900M . These messages just tell that the PIM adjacency failed and then was created again but i do not understand at the moment why i am seeing the logs constantly. Config has been checked and all is fine.
The 4900M ( with WS-X4908-10GE ) is connected to 6500-E (WS-X6708)
code on 4900M is cat4500e-entservicesk9-mz.122-53.SG1.bin
%PIM-5-NBRCHG: neighbor 10.0.0.1 DOWN on interface TenGigabitEthernet2/1 non DR
%PIM-5-NBRCHG: neighbor 172.16.1.1 DOWN on interface Vlan2502 non DR
%PIM-5-NBRCHG: neighbor 192.168.1.1 DOWN on interface Vlan602 DR
%PIM-5-DRCHG: DR change from neighbor 192.168.1.2 to 192.168.1.1on interface Vlan602
%PIM-5-NBRCHG: neighbor 10.0.0.1 UP on interface TenGigabitEthernet2/1
%PIM-5-NBRCHG: neighbor 172.16.1.1 UP on interface Vlan2502
%PIM-5-NBRCHG: neighbor 192.168.1.1 UP on interface Vlan602
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.