Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

PIM

Hi,

As per PIM behaviour in Dense mode, PIM Dense Mode Asserts - When two routers both forward the same (S, G) multicast traffic onto a

common multi-access LAN, duplicate traffic is generated.

But if we have configured PIM in Sparse mode with Anycast configuration. Is it possible that we can have duplicate multicast packet with indicatino of assert message?

I'm seeing this in Multicast traffic when i have configured Anycast.

Can any PIM Multicast expert help to understand better.

Rgds

Chintan

1 REPLY
Bronze

Re: PIM

you may configure PIM sparse-dense mode to eliminate the likelihood of duplicate frames...

155
Views
0
Helpful
1
Replies