Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

ping only success with 1 byte lesser then the mtu set in ppp multilink

Hi All,

  i have a stituation which i needed help in explain on this situation.i have 2 routers and i have configure 2 serial links on each router into  a ppp multilink 1, when i ping both ways from both router i need to ping with 1 byte lesser then the mtu size i set. As show below

routerA#ping 202.122.151.129 df si 1604

Type escape sequence to abort.

Sending 5, 1604-byte ICMP Echos to 202.122.151.129, timeout is 2 seconds:

Packet sent with the DF bit set

!!!!!

Success rate is 100 percent (5/5), round-trip min/avg/max = 12/12/12 ms

routerA#ping 202.122.151.129 df si 1605

Type escape sequence to abort.

Sending 5, 1605-byte ICMP Echos to 202.122.151.129, timeout is 2 seconds:

Packet sent with the DF bit set

.....

Success rate is 0 percent (0/5)

routerA#sh run int multil 1

Building configuration...

Current configuration : 384 bytes

!

interface Multilink1

mtu 1605

ip address 202.122.151.130 255.255.255.252

load-interval 30

ppp multilink

ppp multilink group 1

end

routerA#

============================================

routerB#ping 202.122.151.130 df si 1604

Type escape sequence to abort.

Sending 5, 1604-byte ICMP Echos to 202.122.151.130, timeout is 2 seconds:

Packet sent with the DF bit set

!!!!!

Success rate is 100 percent (5/5), round-trip min/avg/max = 8/10/12 ms

routerB#ping 202.122.151.130 df si 1605

Type escape sequence to abort.

Sending 5, 1605-byte ICMP Echos to 202.122.151.130, timeout is 2 seconds:

Packet sent with the DF bit set

.....

Success rate is 0 percent (0/5)

routerB#

routerB#

routerB#sh run int multil 1

Building configuration...

Current configuration : 380 bytes

!

interface Multilink1

mtu 1605

ip address 202.122.151.129 255.255.255.252

load-interval 30

ppp multilink

multilink-group 1

end

Can some one explain to me why i have to ping with 1 byte lesser then mtu set on ppp multilink ??

Thanks

168
Views
0
Helpful
0
Replies