Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Ping Problem

Hi, I have a network of 3 switches given in the diagram. I can ping any Ip from 2960_1 but I cannot ping even gateway from 2960_2. Can you tell me the problem. But can pingable any IPS from the Laptop connected that switch

7 REPLIES

Re: Ping Problem

The Link between C2960-1 and C2960-2 should be a Trunk link.

HTH

Mohamed

New Member

Re: Ping Problem

yes I have reconfigured as a trunk but still I cannot ping any ips from the switch. but I can ping from that Laptop.

Cisco Employee

Re: Ping Problem

Goutam,

Do you have any IP address assigned on 2960_2. If yes, then what and on which interface / SVI?

Regards

Vaibhav

New Member

Re: Ping Problem

No, only one loopback Interface configured. But in 2960_1 there is no IP configured except one Management Vlan with Management IP. That mean do I need to configure the Vlan 800 with IP address in 2960_2 Switch?

Hall of Fame Super Gold

Re: Ping Problem

yes

Purple

Re: Ping Problem

How are you going to ping anything if switch 2 doesn't have an ip address on it ?

New Member

Re: Ping Problem

Just as a tip, you can create the diagram in Visio then save it as a picture/jpg file.

153
Views
0
Helpful
7
Replies
CreatePlease to create content