Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

ping with datagram size

Hi,

I am pinging to a outside IP from my network switch, its pinging fine with datagram size 500, but more than 500 datagram its not pinging any IPs. can you tell me what may be the problem/

6 REPLIES
New Member

Re: ping with datagram size

hi gautam,

if i understand your question correctly. there might be drops of packets

on the path the packet travels

so make sure the path the packets travels

does not have congestion

rgds/shiva

New Member

Re: ping with datagram size

also i have checked in the same network segment, I m pinging to firewall connected direcly to switch, its getting drop more than 500 datagram size. My switch is 3750

New Member

Re: ping with datagram size

your question is very specific

pls specify

where the source you originate the ping ?

destination ?

any intermediate devices in the path ?

how u say 500 datagrams ?

is it size of packet used in ping ?

rgds/shiva

New Member

Re: ping with datagram size

Hi,

If your are pingen to and public network, DSL, Frame Relay. Check the mtu size of your outside network.

Regards

J.

New Member

Re: ping with datagram size

I am not pinging public network i m pinging in same private segment. switch to firewall, which is directly connected.

New Member

Re: ping with datagram size

I am pinging from my network switch to Nokia firewall which is directly connected. there is no imtermediate device. source is my switch and destination is my firewall, I am setting datagram size 500 ( default is 100), yes.

426
Views
0
Helpful
6
Replies