Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

PIX 501 & 506 PDM Question

Hello,

I have a question regarding the PIX 501 and 506e using PDM. When I first set up the device I am able to connect through PDM using the default settings, however when I change the internal IP interface and configure the laptop I?m using to utilize that network I am no longer able to connect using PDM. In order to gain access again, I have to unplug the firewall so it resets to factory settings. Thanks for any help in advance!

Greg

2 REPLIES
Hall of Fame Super Blue

Re: PIX 501 & 506 PDM Question

Hi Greg

Try adding to the config

http "your new IP address" 255.255.255.255 inside"

You need to allow your internal IP address to have access.

HTH

Jon

Re: PIX 501 & 506 PDM Question

try

http 0.0.0.0 0.0.0.0 inside

telnet 0.0.0.0 0.0.0.0 inside

or per subnet

http 192.168.1.0 255.255.255.0 inside

telnet 192.168.1.0 255.255.255.0 inside

This way you are not bound to your IP only accesing the pix, you can now access it from any inside subnet.

HTH

Jorge

250
Views
0
Helpful
2
Replies
CreatePlease login to create content