Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
240
Views
0
Helpful
1
Replies

PIX processor load high.

KlediBodinaku24
Level 1
Level 1

‎12-22-2006 12:28 AM - edited ‎03-05-2019 01:28 PM

I have a 515E PIX. Sometimes the processor load gets very high. I have noticed that the process who is using the processor is IP Address Assign process. I have about 25 users who log in with Cisco VPN Client to which it has been assigned a pool of IP's and from that pool i have assigned a static IP to each user.

When the process load gets high the PIX does not allow the other users to log in.

When i Disable and than enable the Use of internal address pools everything goes to normality.

Can someone help me.

Regards

Labels:
0 Helpful
1 Reply 1

sourabhagarwal
Level 4
Level 4

‎12-22-2006 01:17 AM

check the number of concurrent sessions estabalsihed in PIX using "show connection" command. This will tell you if any specific IP is initiating many sessions and on which TCP/UDP port.

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents
Review Cisco Networking products for a $25 gift card