Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

PLATFORM_UCAST-6-PREFIX error

a 3750 have this problem:

tech note

Cisco IOS Software, C3750 Software (C3750-IPSERVICESK9-M), Version 12.2(50)SE1,

RELEASE SOFTWARE (fc2)

Copyright (c) 1986-2009 by Cisco Systems, Inc.

Compiled Mon 06-Apr-09 08:19 by amvarma

Image text-base: 0x00003000, data-base: 0x01D00000

ROM: Bootstrap program is C3750 boot loader

BOOTLDR: C3750 Boot Loader (C3750-HBOOT-M) Version 12.2(44)SE5, RELEASE SOFTWARE

(fc1)

in the log there is this problem:

*Mar 1 12:38:14: %PLATFORM_UCAST-6-PREFIX: One or more, more specific prefixes

could not be programmed into TCAM and are being covered by a less specific pref

ix

if i wiev the explain of this error in cisco.com tell this:

Error Message PLATFORM_UCAST-6-PREFIX: One or more, more specific prefixes could not

be programmed into TCAM and are being covered by a less specific prefix

Explanation A more specific prefix could not be programmed into Ternary Content Addressable Memory (TCAM) and is covered by a less specific prefix. This could be a temporary condition. The output of the show platform ip unicast failed route privileged EXEC command lists the failed prefixes.

Recommended Action No action is required.

But , how can i to do for to remove this error or warning from the log?

thanks for yuor help

fcostalunga

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Silver

Re: PLATFORM_UCAST-6-PREFIX error

Hello Francesco,

the 6 is for the severity level of the log message if you don't use ipv6 the routing sdm can be the right choice for use.

Hope to help

Giuseppe

2 REPLIES
Hall of Fame Super Silver

Re: PLATFORM_UCAST-6-PREFIX error

Hello Francesco,

you may need to change the SDM template that decides how the TCAM resources are used.

see

sdm prefer {default | dual-ipv4-and-ipv6 {default} | qos}

http://www.cisco.com/en/US/docs/switches/lan/catalyst3750/software/release/12.2_40_se/configuration/guide/swsdm.html

you may need to use a template more router oriented like dual-ipv4-and-ipv6 if you use IPv6

if you decide to change the SDM template you need to save the config and then to reload.

Hope to help

Giuseppe

Hall of Fame Super Silver

Re: PLATFORM_UCAST-6-PREFIX error

Hello Francesco,

the 6 is for the severity level of the log message if you don't use ipv6 the routing sdm can be the right choice for use.

Hope to help

Giuseppe

1868
Views
0
Helpful
2
Replies
CreatePlease to create content