Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Please help with Cisco 2651xm

Please help me configure my 2651xm router.

My DSL line has a modem of Zyxel P-2612 and I want to connect it to fa0/0 on 2651xm and fa0/1 to switch..

anyone help me configure this connection?

 

Thank you in advance..
 

2 REPLIES

Do you have any existing

Do you have any existing configuration? Your config should look something like this:

interface F8

ip nat inside

interface G0

ip nat outside

ip access-list standard NAT
 permit 192.168.11.0 0.0.0.255

ip nat inside source list NAT interface G0 overload

New Member

Hi,  If your modem has one

Hi, 

 

If your modem has one ethernet or Fastethernet port, you can connect it directly on you f0/0 and connect you switch on f0/1 port, 

 

secondly, give those IP addresse, and activate routage.

 

Exemple:

Router(config) int f0/0

Router(config-if)ip address 63.0.0.1 255.255.255.0

Router(config-if)no shut

 

Router(config)int f0/1

Router(config-if) ip address 10.0.0.1 255.0.0.0

Router(config-if)no shut

 

Router(config) ip route 0.0.0.0 0.0.0.0 fa0/0

 

this simply configuration cant work fine il you have modem with port Ethernet or Fastethernet port

 

Good luck,

 

CEDRIC

26
Views
0
Helpful
2
Replies