Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

%PM-4-ERR_DISABLE: link-flap error detected on Fa0/41,

HI

My environment have two device ,a cisco css11501 and a cisco 2960 ,when I reboot CSS11501 then 2960 shutdown fa0/41

I command "sh logging | in 0/41" just up down two time,not  five times in 10 seconds

.May 17 11:13:18: %LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0/41, changed state to down

.May 17 11:13:19: %LINK-3-UPDOWN: Interface FastEthernet0/41, changed state to down

.May 17 11:14:53: %PM-4-ERR_DISABLE: link-flap error detected on Fa0/41, putting Fa0/41 in err-disable state

.May 17 13:44:35: %LINK-3-UPDOWN: Interface FastEthernet0/41, changed state to up

.May 17 13:44:36: %LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0/41, changed state to up

can hlep me

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Gold

%PM-4-ERR_DISABLE: link-flap error detected on Fa0/41,

Could be a faulty Ethernet cable.

4 REPLIES
Gold

%PM-4-ERR_DISABLE: link-flap error detected on Fa0/41,

Hi,

Issue this command, see (copy) the results: show errdisable flap-values

plz Rate if it helped.

Soroush.

Hope it Helps!

Soroush.
New Member

%PM-4-ERR_DISABLE: link-flap error detected on Fa0/41,

hi

I'm show errdisable flap-values information

ErrDisable Reason    Flaps    Time (sec)

-----------------    ------   ----------

pagp-flap              3       30

dtp-flap               3       30

link-flap              5       10

grateful to have you help


Gold

%PM-4-ERR_DISABLE: link-flap error detected on Fa0/41,

hmmm,bad cable, duplex mismatch, or bad (GBIC) card could make this trigger... check them out !

plz Rate if it helped.

Soroush

Hope it Helps!

Soroush.
Hall of Fame Super Gold

%PM-4-ERR_DISABLE: link-flap error detected on Fa0/41,

Could be a faulty Ethernet cable.

4026
Views
0
Helpful
4
Replies
CreatePlease login to create content