08-10-2014 06:48 AM - edited 03-07-2019 08:20 PM
Hello,
I having issue where 6 WLAN AP's not coming back uo after reboot and IOS upgrade of 3560 POE swtiches - . Prior to changes here most if not all ALL the 23 Aps were mainly on one switch, Now after these changes they are now spread over three switches ( 3560's) - with 17 coming back on line
I am sure its not the power limitation of the switch(s) as the one switch I am TS at present had a fairly large allocation of the aps attached prior to ios upgrade and reload. and the available power value now showing is applicable.for 8 AP's
I have tried various TS steps to try and bring them back up - A couple of things I would like to try but I am restricted to do so is to check the APS physically or downgrade the ios!
Any input on this matter would be truly appreciated.- (attached is the log buffer debug)
res
Paul
08-10-2014 02:52 PM
c3560-ipbase-mz.122-25.SEE2.bin
You upgraded the IOS to the switch? I shudder at the thought of what old version did you upgrade FROM.
Available:370.0(w) Used:110.4(w) Remaining:259.6(w)
You've got more than enough PoE left.
Only two things comes to my mind:
1. Cable issue - Unfortunately, the 3560 is a non-GigabitEthernet and this particular sub-model does NOT support TDR.
2. Hardware failure - Read THIS.
08-10-2014 11:28 PM
Hello
Cheers leo
"You upgraded the IOS to the switch? I shudder at the thought of what old version did you upgrade FROM." - Considering the importance of this IOS upgrade I am on the understaning this is a major step for them! - Crazy
Thanks for the url link mush appriecated
res
Paul
08-11-2014 01:26 AM
Considering the importance of this IOS upgrade I am on the understaning this is a major step for them!
ROF&LMAO!
From 12.X to 12.2(25)SEE2 is a "major step"?
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: