Hi, I have several 3550 switches which I am using to limit the bandwidth of users. I would like to have a policy to limit bandwidth to 5M down, 1M up when going off net, and limit it to 30M up/down when going on net. How would this be accomplished?
When you say "going on/off net", are you referring to users exiting your LAN to the WAN and vice versa via a router or are you referring to strictly LAN/L2 traffic moving inbetween different portions of your LAN?
Well, you can match specific traffic with ACL's, define the bandwidth limitations with by defining the QoS policer with burst limits and exceed actions, define the traffic classes and group your matched traffic in these, then define a policy-map and attach the policer to the traffic classes. Once that's done, apply it to an interface in an inbound/outbound direction. The big thing here will be how you decided to mark your traffic, be it source/destination IP, DSCP/CoS markings, source/destination port #'s, etc. Here's a link to a couple articles that should help you out.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.