I've one Cisco 3750G-12S with ip routing enable, the swtich is with IP Service firmware, with PRR support.
Currently set my default static route 0.0.0.0 0.0.0.0 10.1.18.71 to my Firewall A
Currently all of the VLAN for will be routed to 10.1.18.71
I've created a new VLAN 2 for my 10.1.2.0/24 network with the VLAN interface 2 ip address 10.1.2.10, my intention is to route 10.1.2.0/24 traffic to my 10.1.2.1 by creating the access list and route-map.
I've created an access-list & route-map as below.
access-list 101 permit ip 10.1.2.0 0.0.0.255 any
no cdp run
route-map route10traffic permit 10
match ip address 101
set ip next-hop 10.1.2.1
I've configure my test pc with a static ip and my gateway pointing to 10.1.2.10 (VLAN 2 gateway) , i'm not able to route to 10.1.2.1. Any idea ?
Also, the configs which you posted doesn't show anything wrong. It should also work fine. To troubleshoot further, check if the 10.1.2.0/24 exists in the routing table. Could you please post me the show ip route output?
The trunk link is because the firewall B is located @ another location which is passing throught a switch. My switch is a 3750 12 fiber port switch. The interface 6 is the trunk link to my switch where my firewall B is located.
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...