Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Policing: Calculate burst rate

Looking at configuring policing on a layer3 port on a 6500 switch. How do I calculate the burst rate to limit the port to allow a max of 600MB ingress/egress on a 1GB port

### 6500 ###

!- QOS

mls qos

!- ACL

access-list 101 permit tcp 172.16.35.152 0.0.0.0 172.18.0.0 0.0.0.255

access-list 101 permit tcp 172.16.38.100 0.0.0.0 172.18.0.0 0.0.0.255

access-list 102 permit tcp 172.18.35.125 0.0.0.0 172.16.0.0 0.0.0.255

access-list 102 permit tcp 172.18.38.100 0.0.0.0 172.16.0.0 0.0.0.255

!- class map

class-map Police

match ip address 101

match ip address 102

!- Policy map

policy-map Traffic

class Police_OUT

police 600000000 conform-act transmit exceed-act drop

Please advise.

!- L3 Port

int G5/1

service-policy in traffic

service-policy out trafic

2 REPLIES
New Member

Re: Policing: Calculate burst rate

I don't think the 6500 will support full MQC. Commands like police, bandwidth, etc. are not going to be taken.

Can anyone else confirm?

New Member

Re: Policing: Calculate burst rate

Sorry, just realized I gave you an answer that provided zero help. You will want to check out the 6500 documentation for PFC QoS. Specifically the sections for aggregate and micro-flow policers. Basically, you build the mls qos aggregate-policer, then apply that to the class-map.

http://www.cisco.com/en/US/docs/switches/lan/catalyst6500/ios/12.2SXF/native/configuration/guide/qos.html

1002
Views
0
Helpful
2
Replies