Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Policing not working on 6509 port.

I'm trying to police traffic from a source to 1.5mbps going out of a gig port on a 6509 sup720 IOS 2.2(18)SXE.

Here is the class map and policy map:

class-map match-any DVR

match access-group 130

!

!

policy-map DVR-test

class DVR

police cir 1544000 bc 48250 be 48250 conform-action transmit exceed-action drop

access-list 130 permit IP host 172.26.1.5 any

Here is the interface config:

interface GigabitEthernet2/5

description B138 .43.146

ip address xxx.xxx.xxx.xxx 255.255.255.128

ip helper-address xxx.xxx.xxx.xxx

load-interval 30

mls qos trust dscp

service-policy output DVR-test

Here is the output of 'sh policy-map int':

ROC-6509-DU-B#sh policy-map int

GigabitEthernet2/5

Service-policy output: DVR-test

Class-map: DVR (match-any)

1490981 packets, 202422171 bytes

30 second offered rate 4549000 bps, drop rate 0 bps

Match: access-group 130

1490559 packets, 202276188 bytes

30 second rate 4547000 bps

Class-map: class-default (match-any)

64767 packets, 44867028 bytes

30 second offered rate 647000 bps, drop rate 0 bps

Match: any

There is no reference to policing in the 'show policy-map int' and the output of 'sh mls qos ip int g2/5' doesn't show any policed packets:

ROC-6509-DU-B#sh mls qos ip g2/5

[In] Default. [Out] Policy map is DVR-test

QoS Summary [IPv4]: (* - shared aggregates, Mod - switch module)

Int Mod Dir Class-map DSCP Agg Trust Fl AgForward-By AgPoliced-By

Id Id

-------------------------------------------------------------------------------

Gi2/5 5 In Default 0 0* No 0 323360701600 0

Is my policy-map incorrect?

2 REPLIES
Cisco Employee

Re: Policing not working on 6509 port.

CIR is not supported on ethernet interfaces. Use an aggregate or individual policer

http://www.cisco.com/univercd/cc/td/doc/product/lan/cat6000/122sx/swcg/qos.htm

New Member

Re: Policing not working on 6509 port.

Thanks for the link. But check out the chapter starting on page 42-120 almost at the end of the document, where it gives an example of a policy map for an ethernet interface with policing:

policy-map IPPHONE-PC

class CLASSIFY-OTHER

police 50000000 1562500 conform-action set-dscp-transmit default exceed-action drop

It states that "This example configures the CIR to be 50 Mbps."

Just below that it states: "This is a basic example of a single rate per-interface aggregate policer. The Supervisor Engine 2 and Supervisor Engine 720 forwarding engines also support a dual-rate policer for providing both CIR and peak information rate (PIR) granularity."

So now I am confused. Any other insight into this?

196
Views
0
Helpful
2
Replies
CreatePlease login to create content