Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Policing on catalyst 6509

Hi all.

I'd like to configure policing on a catalyst 6509 (sup32 pfc3 IOS 12.2SXF Adv IP Serv) on the following interface:

WS-X6148-GE-TX and WS-X6148A-GE-TX.

I've used MQC: class-map with command police or police-aggregate..but when I've tried to apply it on the interface it says that 'MQC is not supported on this interface'.

The interface is configure as L2 in access on a specified vlan.

The command rate-limit is not supported too..

Any suggestion?

Many thanks in advance for your support

7 REPLIES
New Member

Re: Policing on catalyst 6509

Hi

MQC is not supported on ethernet interfaces whose QOS behavior is managed by the PFC. Go the the QOS chapter and you will find different ways to configure QOS feature which depend of the PFC

Regards

New Member

Re: Policing on catalyst 6509

Hi,

MQC is not supported ok!

But I'm tring to do policing...and according to the QOS chapter it's supported on egress and ingress.

Can the PFC3 be the problem?

In the doc there is only pfc3A pfc3B and pfc3BXL..

Thanks again

New Member

Re: Policing on catalyst 6509

I've solved the issue:

The PFC3 provides egress PFC QoS only for Layer 3-switched and routed traffic on egress Layer 3

interfaces (either LAN ports configured as Layer 3 interfaces or VLAN interfaces).

Since I've the a PFC3 with Layer 2 switched traffic..I can't apply pfc qos!

Is it ok?

Thanks

New Member

Re: Policing on catalyst 6509

You can apply QOS policies either layer 2 or layer 3 interfaces.

see the followinh URL :

http://www.cisco.com/en/US/partner/docs/switches/lan/catalyst6500/ios/12.2SX/configuration/guide/qos.html#wp1679436

I don't know in detail what you want to , but I expext this URL will give you the answer

New Member

Re: Policing on catalyst 6509

Thanks a lot for the URL.

As I've written in the previous post, even in your doc there is the answer I've just found:

The PFC3 provides egress PFC QoS only for Layer 3-switched and routed traffic on egress Layer 3 interfaces (either LAN ports configured as Layer 3 interfaces or VLAN interfaces).

So I need a PFC3x to make egress policing...on my L2 interface.

Thanks again

Gianluca

New Member

Re: Policing on catalyst 6509

In the doc, it is said that you can apply a policer to a port-chanel(it is not told level 2 or 3)So you can try to define a port chanel interface with only one interface in it (the one on witch you want to have the policing action)

Regards

New Member

Re: Policing on catalyst 6509

If a policer doesn't work you can perhaps try this behavior(it is just an idea).

You classify your output traffic so you map the traffic you want to police in a specific queue. You tune the bandwidth of this queue so that you permit only the bandwidth you want to allocate to this traffic.After the traffic will be dropped.

Regards

181
Views
0
Helpful
7
Replies