I have a problem with Policy Based Routing on a Cisco Catalyst 6500 with IOS ipservicesk9-mz.122-33.SXH2a.
I try to redirect traffic, and only that traffic, for machines with private ip address (10.10.10.0/24) to the port TCP/1111
of a server 195.x.x.1 in public ip. The principle is: my 10.10.10.0/24 machines emit traffic bound for the port
tcp/1111 to 195.x.x.1 , the PBR on the 6500 router intercepts traffic which sends it on a Linux NAT (10.10.10.2) that translate through his second interface (public) on the destination server (195.x.x.1). The NAT server can not be made from 6500 but from a different machine for other reasons. The Policy Based Routing (ip policy route-map) is applied on a vlan interface, I also experimented with on a physical interface without further success.
The Linux NAT server is working properly.
Here, the Policy Based Routing (route-map) is not working. Here is the conf:
Thank, no traffic is redirected from 6500 to the NAT server. I enabled the log on my ACL-TST and a tcpdump on the interface 10.10.10.2 of my NAT server, no redirected traffic is visible. I feel that this route-map doesn't work. I also have another road-map on 6500 (route redistribution) is not working also, do you think the two might be related?
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...