03-01-2010 01:49 AM - edited 03-06-2019 09:56 AM
Hi
I am getting following status of port and which is weird for me. Please help me to understand why this status comes because have never seen this status in my carrier of any port
Swtich#sh int status | in 4/48
Fa4/48 Storage monitoring 325 full 100 10/100BaseTX
Swtich#sh run int f4/48
Building configuration...
Current configuration : 191 bytes
!
interface FastEthernet4/48
description Storage
switchport access vlan 325
speed 100
duplex full
no snmp trap link-status
tx-queue 3
priority high
spanning-tree portfast
end
Regards
Jagdev
Solved! Go to Solution.
03-01-2010 02:22 AM
From
http://www.cisco.com/en/US/docs/switches/lan/catalyst6500/catos/5.x/configuration/guide/span.html
A destination port (also called a monitor port) is a switch port where SPAN sends packets for analysis. Once a port becomes an active destination port, it does not forward any traffic except that required for the SPAN session.
Just my guess, that the destination port is the monitoring port....could be wrong.
03-01-2010 01:59 AM
Jagdev
This could be because you have a SPAN/RSPAN session on your switch and this port is included. Can you run a "sh monitor" on the switch and post the output ?
Jon
03-01-2010 02:22 AM
From
http://www.cisco.com/en/US/docs/switches/lan/catalyst6500/catos/5.x/configuration/guide/span.html
A destination port (also called a monitor port) is a switch port where SPAN sends packets for analysis. Once a port becomes an active destination port, it does not forward any traffic except that required for the SPAN session.
Just my guess, that the destination port is the monitoring port....could be wrong.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide