how that data has been used in Switch B? If data to be accessed between two vlans, then allow that server on Switch A VLAN on that trunk and create a route (inter VLAN Routing on Switch B with the help of Router it is connected ) or if its used in same vlan that Server on Switch A, then allow that vlan on that trunk interface
The data on Switch B goes out a Port which has an L2 connection to a remote data center. So the port has an IP assigned, 10.10.10.101 I have a route on switch B that says 10.20.20.0 255.255.255.0 10.10.10.101. This creates the next hop and data can traverse the L2.
So should the route on Switch A say 10.30.30.0 255.255.255.0 10.10.10.101?
This document gives several answers on frequently asked questions for PFRv3 channel state behavior.
Q1: What are all the channel operational states from a BR (border role) perspective and what are the rules/conditions to be in each st...
The need was to reach an host inside a LAN through a VPN connection managed by the LAN gateway (Cisco 1921).
The LAN gateway performs NAT and there was a dedicate nat rule for the host i wanted to reach through VPN.
I couldn't connect to the hos...