I am trying to configure some 3020 blade center interconnects for an HP blade center for the first time.
I have placed 3 interfaces in a port channel on the interconnect and upstream switch. However the port-channel is down and down on both devices. The respective interfaces are up and up, except for the Gi0/1 interface on the interconnect which is set to track the state of the relevant port channel.
If I remove this link state tracking, the interface relating to the blade comes up and I can ping the interconnect from the blade and vice versa, but cannot ping from the interconnect to the upstream switch.
We are pleased to announce availability of Beta software for 16.6.3.
16.6.3 will be the second rebuild on the 16.6 release train targeted
towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are
looking for early feedback from customers befor...
Introduction Featured Speakers Luis Espejel is the Telecommunications
Manager of IENova, an Oil & Gas company. Currently he works with Cisco
IOS® and Cisco IOS XE platforms, and NX to some extent. He has also
worked as a Senior Engineer with the Routing P...
In this session you can learn more about Layer 3 multicast and the best
practices to identify possible threats and take security measures. It
provides an overview of basic multicast, the best security practices for
use of this technology, and recommendati...