I was asked to set up a port channel from my 4900M to a couple of NETAPP servers, can this be done. There are two gig ports on each servers. Port channels between switches is easy but can it be done to end items. I tried but I counldn't get my Port-Channels to come up? Maybe it's my configs? If it's just a question of failover, I have the two 4900M stacked and perfer to use HSRP.
I was told the servers were set up for LACP, but i keep getting a "LACP currently not enabled on the remote port" message. I assumed it was on the server end but there was no server techs available. Was i on the right path for my configs?
Thanks. I didn't consider a vlan setting on the NICs. Do i need to trunk? Am i making this harder than it needs to be? Should I just make my gig ports access ports? My goal is just to keep things at layer 2 for these customers. Already have HSRP, layer 3 and OSPF point-to-point routing running on the switch for other customers.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.