Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

Port-channel through Cisco ASA in transparent mode

Hello Cisco Support ForumTeam!

 

    Can a pair of Cisco ASA in Transparent mode allow the formation of a Port-cannel between two Cisco Catalyst 4500X in VSS?

 

The ASA is configured in active/standby and is located between the two VSS switches (Core and Distribution layer switches).

 

How the ports need to be configured on the switches side for the firewall interfaces; trunk or switchport?

 

If anyone done it before, please share.

 

Thanks in advanced for your support guys!

 

Regards.  

1 ACCEPTED SOLUTION

Accepted Solutions
VIP Super Bronze

Hi,What version of IOS are

Hi,

What version of IOS are you running on the ASAs?

see table-12-3 in this link:

http://www.cisco.com/c/en/us/td/docs/security/asa/asa84/configuration/guide/asa_84_cli_config/interface_start.html

Also, since the 4500x are in VSS mode, you need to bundle one link from each switch and use LACP.

HTH

 

3 REPLIES
VIP Super Bronze

Hi,What version of IOS are

Hi,

What version of IOS are you running on the ASAs?

see table-12-3 in this link:

http://www.cisco.com/c/en/us/td/docs/security/asa/asa84/configuration/guide/asa_84_cli_config/interface_start.html

Also, since the 4500x are in VSS mode, you need to bundle one link from each switch and use LACP.

HTH

 

New Member

Hello Reza and thanks for

Hello Reza and thanks for your reply;

  The ASA version is 7.x if I am not mistaken. Excellent information.

 

Thanks again for your great support!

 

Regards,

 

VIP Super Bronze

Hi,Glad to help and thanks

Hi,

Glad to help and thanks for the rating.

Good Luck

399
Views
0
Helpful
3
Replies
CreatePlease to create content