I am trying to create a port-channel between a cisco CGESM blade switch using 2 fibre spf modules, and a cisco 4507R WS-X4418-GB module.
I am unable to get the port channel to go active when I use 2 ports on the same WS-X4418-GB (and I have tried several different gbics, ports and fibre cables). I am however able to get the port channel active when I split the 2 interfaces of the port channel over 2 X4418 modules (i.e one port on each card used on the 4500 side)
Is this the correct behaviour, or am I missing something? I have had a collegue verify my config, which is minimal and he can see nothing wrong.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.