Port-channel

[henokk601]

Hi Everyone... i was configuring portchannel on a router and i got this error message any help plz 

Router(config)#interface range tenGigabitEthernet 0/0/0-1
Router(config-if-range)#channel-group 24 mode active
% Range command terminated because it failed on TenGigabitEthernet0/0/0

[paul driver]

Hello

What switch are you using - What mode are those ports in?

res
Paul

[Mark Malone]

I think your range might be missing the gap I think from looking at that , theres a space after the 0 then the - another space then 1 , like below

int range tenGigabitEthernet 1/1/1 - 2

[henokk601]

hey  paul driver The router is ASR 1001-X