06-16-2014 11:13 AM - edited 03-07-2019 07:44 PM
Hi experts,
we have 2 x 6509-E chassis NOT doing VSS, having a 10g module ( WS-X6708-10GE ) in each chassis. We plan to get another 10g module (same as existing) for each chassis. I was planning to move some ports from the existing module to the new module.
Question - Is a port channel supported across 2 modules on the same switch?
thnx
Solved! Go to Solution.
06-16-2014 12:16 PM
Hey,
Cross module etherchannel is supported as long as physical characteristics of ports match. Do check the QoS properties as well.
Also check the restrictions section as well:
http://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst6500/ios/12-2SX/configuration/guide/book/channel.html#wp1020420
HTH.
Regards,
RS
06-16-2014 12:16 PM
Hey,
Cross module etherchannel is supported as long as physical characteristics of ports match. Do check the QoS properties as well.
Also check the restrictions section as well:
http://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst6500/ios/12-2SX/configuration/guide/book/channel.html#wp1020420
HTH.
Regards,
RS
06-16-2014 01:15 PM
Thanks guys, I have exactly two same modules in the chassis, so qos should not be an issue among them.
06-16-2014 12:59 PM
It is recommended to channel ports on blades with the same queue types.
This behavior can be bypassed by command.
"no mls qos channel-consistency"
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide