I am trying to connect to a Cisco 837 by the console port and the only thing that appear in the screen are strange symbols. I restarted the router one or two times and tried to connect the console port in another computer but it didn't work.
The configuration of the HyperTerminal is:
Bits per second: 9600
Data Bits: 8
Stop Bits: 1
Flow Control: No.
A last thing. I put in the console port the ADSL rj11 by a mistake. I don't know if there is any relation.
The port speed is set as something other than 9600 , you are going to have to runn thru all the speeds in increments of 9600 until you get a readable output . Someone may have had to xmodem in a image and increased the console port speed. If you get it to work check the config register , should be 0x2102.
We are pleased to announce availability of Beta software for 16.6.3.
16.6.3 will be the second rebuild on the 16.6 release train targeted
towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are
looking for early feedback from customers befor...
Introduction Featured Speakers Luis Espejel is the Telecommunications
Manager of IENova, an Oil & Gas company. Currently he works with Cisco
IOS® and Cisco IOS XE platforms, and NX to some extent. He has also
worked as a Senior Engineer with the Routing P...
In this session you can learn more about Layer 3 multicast and the best
practices to identify possible threats and take security measures. It
provides an overview of basic multicast, the best security practices for
use of this technology, and recommendati...