I am trying to connect to a Cisco 837 by the console port and the only thing that appear in the screen are strange symbols. I restarted the router one or two times and tried to connect the console port in another computer but it didn't work.
The configuration of the HyperTerminal is:
Bits per second: 9600
Data Bits: 8
Stop Bits: 1
Flow Control: No.
A last thing. I put in the console port the ADSL rj11 by a mistake. I don't know if there is any relation.
The port speed is set as something other than 9600 , you are going to have to runn thru all the speeds in increments of 9600 until you get a readable output . Someone may have had to xmodem in a image and increased the console port speed. If you get it to work check the config register , should be 0x2102.
We have 3 identical switches configured by someone else and would like to claim some of the Gigabit ports(G1/G2/G3/G4) for use on servers. When we try to change the wiring and configuration, we run in to connectivity issues. Attached is a des...
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...