Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Port Counter Errors

Hi,

In my Network is having 6509-E and 4006 on IOS and catos.couple of the interfaces/ports on Full Duplex with speed auto.

Pointing out the issue is with port counter errors facing ---> Alignment,FCS and Input errors are increasing the count.

how can i rectify this errors.

Thanks in advance!

3 REPLIES

Re: Port Counter Errors

Typically the errors you are seeing are related to a bad cable, or NIC. Please check the cables and make sure they haven't been mangled, or crimped improperly.... etc

Here is a good troubleshooting guide.

http://www.cisco.com/en/US/products/hw/switches/ps700/products_tech_note09186a008015bfd6.shtml

Mark

New Member

Re: Port Counter Errors

Thanks a lot!! Mark

Drill down the list?

might correct the errors

Purple

Re: Port Counter Errors

Check on each end of the link on these , the settings must match , if the speed and duplex is auto on one end then it must be auto on the other end , if hardcoded to say 100/full then the other end must be hardcoded also . If you are attaching 2 cisco devices then auto/auto should work fine .

131
Views
4
Helpful
3
Replies
CreatePlease to create content