Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

port fast and 3500 XL Switch

Hi,

i got 2 3500 series XL switches for labing. I already know that I can't use int range for configs because of the old IOS 12-0-5.WC17, its actually the highest one that can run on it, memory limitations for higher IOS i gather.

Anyway, is there a way to add portfast to all access ports on this so i don't have to do it manually for all ports. Thanks

1 ACCEPTED SOLUTION

Accepted Solutions
VIP Super Bronze

Re: port fast and 3500 XL Switch

Hi,

There is no other way.  You have to do it one at the time for each interface since the interface range is not available

HTH

Reza

5 REPLIES
VIP Super Bronze

Re: port fast and 3500 XL Switch

Hi,

There is no other way.  You have to do it one at the time for each interface since the interface range is not available

HTH

Reza

New Member

Re: port fast and 3500 XL Switch

not even a global command or nothing, ok

VIP Super Bronze

Re: port fast and 3500 XL Switch

VIP Super Bronze

Re: port fast and 3500 XL Switch

New Member

Re: port fast and 3500 XL Switch

yea i was gonna tell you it had both guard and filter but not default in global. defualt is the one im looking for. In order to use guard, portfast has to be enabled. I was hoping for a miracle to have better way of one by one int. IOS limitation confirmed, thanks anyway

608
Views
0
Helpful
5
Replies