Forgive if i am asking a dump question, a link-flap errordisable flap value is 5 flaps in 10 seconds will error-disable a port. I am seeing a port put in to errordisable in less than 5 flaps in about 8 seconds!
Does anyone know what states a port goes in to when it detect a flap? for example when a device connected to the switch reboot, the switch detect a flap right, and "debugging interface state" provides some indication what states the port goes through. if its more than 5 state or flap in 10 seconds, then errordisable!. what i am trying to figure out is, does the 5 flap value related to state of the port when recovery from a flap ?
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...